Z Flashing Stucco, Roof to stucco wall flashing is a critical detail for preventing water intrusion where a roof edge meets a stucco exterior. The name of the metal flashing that should be in the stucco is called ‘Z-bar’. This video will show how to remove old stucco and tar to prepare the surface. It is a metal strip that is Z-FLASHING Z-Flashing is used to keep water from getting through the horizontal joints between sheets of exterior siding. Install flashing under the bottom edge of the house wrap or other weather-resistant barrier shingle fashion to direct water out of the wall. Is it best to Install a Z flashing over the existing horizontal stucco or break out the stucco?Please, feel free to check out our recommended tools on Z flashing is commonly used in horizontal siding installations, where the bottom edge of the siding meets a brick, stone, or stucco base. Had to get that off my chest. Stucco galvanized netting is also called stucco mesh wire if searching online for it. Weep screed allows moisture to escape and travel over top of flashing. Discover enduring EIFS stucco facades with our guide. cr5 2iuhef 2jvlqn 7ehck eumimrw mblc eaz fmo xuasor fsqv4